The following table lists the U-Boot file associated with each ConnectCore 8X variant:

CPU type/ RAM size SOC revision U-Boot file U-Boot defconfig

any

RevC

imx-boot-ccimx8x-sbc-pro-C0.bin-flash_spl

ccimx8x_sbc_pro_defconfig

RevB

imx-boot-ccimx8x-sbc-pro-B0.bin-flash_spl

Check your CPU type, SOC revision, and RAM size on the serial console boot log:

U-Boot SPL dub-2024.04-r2.2+g9218b07cddd+p0 (Feb 24 2025 - 15:03:54 +0000)
Normal Boot
Trying to boot from MMC1
Primary set selected
Load image from MMC/SD 0x5f400


U-Boot dub-2024.04-r2.2+g9218b07cddd+p0 (Feb 24 2025 - 15:03:54 +0000)

CPU:   NXP i.MX8QXP RevB A35 at 1200 MHz at 43C
DRAM:  2 GiB
MCA:   HW_VER=1  FW_VER=1.00
Core:  257 devices, 27 uclasses, devicetree: separate
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... OK
In:    serial
Out:   serial
Err:   serial
Model: Digi International ConnectCore 8X SBC Pro Board.
ConnectCore 8X SOM variant 0x02: 2 GiB LPDDR4, Wi-Fi, Bluetooth, MCA
  Board version 2, ID 135
Boot:  MMC0
Reset cause: POR

 BuildInfo:
  - SCFW 83624b99, SECO-FW c9de51c0, IMX-MKIMAGE 71b8c18a, ATF 1b27ee3
  - U-Boot dub-2024.04-r2.2+g9218b07cddd+p0

flash target is MMC:0
Net:   eth0: ethernet@5b040000 [PRIME], eth1: ethernet@5b050000
Fastboot: Normal
Normal Boot
Hit any key to stop autoboot:  0
=> 
NXP released two revisions of the SOC silicon: revision B0 and revision C0. See SOC revisions for more information.

U-Boot might show less DRAM than the nominal. This is due to elements such as the secure monitor (OP-TEE) reserving part of the memory.