AnywhereUSB 2 Plus: Front panel

 

 

Item Name Description

1

WAN/ETH1

Ethernet port and Ethernet LEDs.

You can connect an STP Cat 7 Ethernet cable.

The Ethernet LEDs shows the status of the Ethernet port:

  • Solid green: A link has been detected.

  • Solid yellow: A Gigabit Ethernet has been detected.

2

USB1

and

USB2

USB ports and LEDS. The USB port supports 1.1, 2.0, and 3.1 USB devices.

The LED illuminates as follows:

  • Yellow: A 1.1 (full speed) USB device is connected to the port.
  • Green: A 2.0 (high speed) USB device is connected to the port.
  • Blue: A 3.0 (super speed) USB device is connected to the port.
  • Red: The LED on USB port 1 is solid red if a firmware update has failed. For more information, see Update the DAL OS system firmware.

Note When connecting a USB cable to a USB port on the Hub, make sure to use a high-quality USB standards-compliant cable.

3

Reset button

Use this button to reset the AnywhereUSB Plus Hub configuration to factory defaults.

4

Power LED

The power LED shows the status of the power when the power cord is connected to the device.

  • Solid blue: The device is powered on.

  • Blinks green and then orange: The Find Me feature has been activated.

5

Power connector

 

Connect the power supply: 5 Volt DC center positive.

The Hub draws 5 Amp maximum when both USB ports are drawing 1.8 Amps each.