status
Use
Type status at the command prompt to display device information.
The status information represents a snapshot in time, and is updated each time you type the status command. The Connect Tank device modem must be connected to the cellular network to be able to capture and display cellular information for the device. The modem is awake for a short amount of time and then automatically disconnects from the network.
You may have to type the status command a few times to makes sure you have a complete set of device status information. This may take between 45 and 60 seconds, depending on how long it takes for the modem to connect. Before and after the modem is connected, only status information about the Connect Tank hardware displays.
Connect Sensor device options
The following information about the Connect Sensor device hardware always displays.
| Option | Description |
|---|---|
| Device Type | Name and version of the device hardware. |
| Device ID | ID number for the Connect Tank device. |
| Firmware Version | Version of the device’s current firmware. |
| UTC Time | Last reported date and time. |
| Battery Life |
Amount of battery life remaining. See View battery life using the CLI. |
Connect Sensor modem and cellular connection options
The following information displays when the modem is connecting or has connected. These fields display depending on the status of the modem connection to the cellular network.
| Option | Description |
|---|---|
| Mobile support software | Version of the mobile software. |
| Device type | Cellular network type the device connects to. |
| Manufacturer | Cellular modem manufacturer. |
| Model | Cellular modem model number. |
| Modem revision | Modem firmware version. |
| Serial number | Modem serial number. |
| Provider | Cellular provider. |
| Phone number | Phone number registered to the activated SIM card. |
| SIM IMSI | Unique user identifier for the cellular network. |
| SIM ICCID | SIM serial number. |
| SIM PIN status | State of the SIM card. |
| Signal strength |
Strength of the cellular signal. See Verify cellular network coverage using the CLI. |
| Signal quality | Quality of the cellular signal. This measures signal interference. |
| Connection state | Cellular connection state. |
| Connection duration | Amount of time the cellular modem was connected during last wake cycle. |
| Disconnect reason | Cause of the cellular modem disconnection during last wake cycle. |
| Connections | Number of cellular connection attempts since power up. |
| Connection errors | Number of failed connections since power up. |
| User disconnects | Number of normal disconnections since power up. |
| Monitoring errors | Number of cellular modem errors since power up. |
| Device resets | Number of times cellular modem was reset to recover from errors since power up. |
PDF
