This command applies changes to all command parameters configured in Command mode.

Any of the following also applies changes the same as issuing an AC command:

  • Exiting Command mode with a CN command.

  • Exiting Command mode via timeout.

  • Receiving a 0x08 API command frame.

  • Issuing a 0x08 Local AT Command API frame.

  • Issuing a remote 0x17 AT Command API frame with option bit 1 set.

Example: Altering the UART baud rate with the BD command does not change the operating baud rate until after an AC command is received; at this point, the interface immediately changes baud rates.