Configure the location with manually defined coordinates

The physical location for a Connect Sensor's location can be determined by manually defining the device's coordinates in the System Location Page.

Note You can also request the location from the device, which is determined using the GPS. See Configure the location with GPS-defined coordinates.

1. Determine the latitude and longitude coordinates for the device's location. You can use the physical address of where the device is located and a mapping application to discover the coordinates.

2. Access the web UI for Connect Sensor from the Device Summary page. The Automation Dashboard displays.

3. Choose Physical I/O > Location Source. For information about the fields on this screen, see Configure the location coordinates for a Connect Sensor.

4. Click Manual Override. The Manual Location Override section displays.

5. In the Latitude and Longitude fields, enter the latitude and longitude coordinates for the device's location.

6. Click Update.

7. Click OK to confirm update.