Step 4: Attach an accessory to the RMS Z45

You can attach an additional accessory to the RMS Z45 using the 3" DIN rail found in the accessory bag and the DIN rail clip attached to the right side of the RMS Z45.

Note To ensure that you can properly close the enclosure, the size of the accessory cannot exceed the height of the 3" DIN rail.

1. Orient the enclosure and the RMS Z45 so the DIN rail clip is on the right side.

   

2. Place the 3" DIN rail against the DIN rail clip.

3. Push the clip up to attach the DIN rail to the RMS Z45.

4. Attach your additional accessory to the DIN rail, following the connection instructions for the accessory.

 

NEXT STEP: Proceed to Step 5: Power the RMS Z45.