Force a full configuration update on a Connect Sensor

Forcing a full configuration update overwrites the entire Connect Sensor configuration on the device based on the Connect Sensor configuration stored in Digi Axess.

The update happens during the next time that the Connect Sensor wakes up and connects to Digi Axess, either at the scheduled wake time or if it is done manually.

Digi recommends only forcing a configuration update when the Sync Status in the Device Summary page shows as Synced but the device configuration is not properly synced and you have physical access to the device.

1. Log into the Connect Sensor web UI on Digi Axess.

2. In the Options section, click Applications. The Available Applications buttons display.

3. Click Automation Control. The Management & Administration buttons display.

4. Click Force Full Config. The Force Full Device Config Update page displays.

5. Click Force Full Config to force a full configuration update for the device. The device's configuration in Digi Axess is pushed to the device and overwrites the device's existing configuration.