Radio configuration and activation on a Z45 Controller

Note By default, the radio is configured for Verizon. Radio configuration is necessary only if you are using an alternate to the M2M Wireless SIM card, or any non-Verizon SIM card.

The Z45 Controller contains a multi-carrier, software-defined radio that must be configured for proper operation on a specific network. By default, the Z45 Controller has Verizon firmware loaded in the radio module, the default Verizon Internet APN selected, and the WAN enabled.

The Z45 Controller provides four options with network-specific radio firmware and configuration information, specifically APN selection and the default WAN connection status.

• AT&T

• Verizon

• Sprint

• Generic: The generic area is designed to accommodate most of the legacy GSM carriers and can actually contain numerous generic carrier configurations, each identified by the combination of the Country Code and Carrier Code portions of the unit’s IMEI.

Configure the Z45 Controller network operation

Follow this process to configure a Z45 Controller:

1. Load a radio firmware image on a Z45 Controller

2. Configure the Radio Firmware and Perform Network Activation