Configure the Radio Firmware and Perform Network Activation

This process requires that a SIM card issued by a carrier matching the currently loaded radio firmware image must be installed to insure that configuration changes are saved in the area associated with the installed firmware image.

1. Load the radio firmware that matches the network provider for your SIM card. See Load a radio firmware image on a Z45 Controller.

2. Access the device's web UI from the Device Summary page.

3. On the wireless configuration screen verify that the correct APN is selected.

   1. Click Admin Main.

   2. From the Interfaces section, click Wireless.

   3. From the Data Connection Configuration section, select Enabled from the Connection State list box.

   4. In the APN Profile Configuration section, select the appropriate APN.

4. Restart the Z45 Controller, by unplugging it from the main power source and then plugging it back in. When the device reconnects to the network, the Link LED is lighted. The selected APN and WAN connection status are saved in the appropriate firmware area.