P0 (DIO10/RSSI/PWM0 Configuration)
This command applies to the XBee 3 802.15.4 RF Module.
Sets or displays the DIO10/RSSI/PWM0 configuration (Micro pin 7/SMT pin 7/TH pin 6).
When configured as RSSI PWM output, the device outputs a PWM signal with a duty cycle equivalent to the dBm of the received packet.
Use RP (RSSI PWM Timer) to configure the timeout.
When configured as PWM output (2): you can use M0 to explicitly control the PWM0 output. When used with Analog I/O support, PWM0 corresponds with ADC0.
Parameter range
0 - 5
| Parameter | Description |
|---|---|
| 0 | Disabled |
| 1 | RSSI PWM output |
| 2 |
PWM0 output. M0 (PWM0 Duty Cycle) or I/O line passing control the value. |
| 3 | Digital input |
| 4 | Digital output, low |
| 5 | Digital output, high |
Default
1
PDF
