A1 (End Device Association)

This command applies to the XBee 3 802.15.4 RF Module.

Sets or displays the End Device association options. These options are only applicable when configured as an End Device by setting CE (Device Role) to 0.

Bit 2 must be set before other options are enabled.

Parameter range

0 - 0x0F (bit field)

Bit field:

Bit	Meaning	Setting	Description
0	Allow PanId reassignment	0	Only associates with Coordinator operating on PAN ID that matches device ID.
		1	May associate with Coordinator operating on any PAN ID.
1	Allow Channel reassignment	0	Only associates with Coordinator operating on matching CH channel setting.
		1	May associate with Coordinator operating on any channel defined in the SC (Scan Channels) mask.
2	Auto Associate	0	Peer-to-Peer operation - Device will not attempt association.
		1	Network End Device - Device attempts association until success. If configured for cyclic sleep, DP (Disassociated Cyclic Sleep Period) is used instead of SP (Cyclic Sleep Period) until the device associates.
3	Poll coordinator on pin wake	0	Pin Wake does not poll the Coordinator for indirect (pending) data.
		1	Pin Wake sends Poll Request to Coordinator to extract any pending data.
4 - 7	Reserved

Default

0