Configure regulatory firmware for testing the cellular component

You must configure the regulatory firmware in order to use the regulatory test commands for testing the cellular component.

Prerequisite

A SIM card must be installed in the XBee.

Configure the regulatory firmware

In XCTU or command mode, set the following configurations:

1. If Bluetooth is not required, turn off Bluetooth. Set BT = 0.

2. Disable USB Direct mode, if it is currently enabled. Set P1 = 0.

3. Disable airplane mode, if it is currently enabled. Set AM = 0.

4. Configure the XBee in transparent mode. Set AP = 0.