Step 4: Verify device registration

After you have registered your device, you can log into Digi Axess and verify that it is mapped correctly.

1. Wake the Connect Sensor using a magnet. See Manually wake the Connect Sensor.

2. Log into Digi Axess.

3. Find the registered device using one of the following methods.

   • Use the Search Devices field in the toolbar to find the device that you just registered. You can search by serial number or location name.

   • Click on the device's location pin in the map.

   • Select a device from the list of mapped devices.

   • Display the devices in the table format, and search for the device.

4. Click on the device location pin or device name from the list of devices to display the device's Device Summary page. The information that displays in the Device Summary page depends on the configuration option you chose during initial registration.

   • Demo Configuration: This is the default configuration, and displays basic information in the Device Summary page: Analog in Voltage, Digital in, and Case temperature.

     

   • Blank Configuration: No data displays. You must manually configure the device in the device's Administration page.

   • Saved Configuration: Data for the options in the saved configuration display.

     

 

 

Set up is complete!