Notification types

The tables below explain the types of notifications that may be sent.

Stale Device Notifications alert

A stale device notification is sent when the device is no longer connecting to Digi Axess. The time threshold can be configured at the device and device group level, and defaults to 24 hours.

• Device not connecting to Digi Axess.

Battery alerts

A battery alert is sent when any of the battery conditions shown below are met.

• Battery Replacement Required

• Battery Replacement Recommended

• Battery Has Been Removed

• Battery Has Been Replaced

• External Power State Change Detected (yellow banner): This notification is sent in a yellow warning banner when Digi Axess has detected that the external power has been disconnected and the device is running on battery power only.

• External Power State Change Detected (green banner): This notification is sent in a green banner when Digi Axess has detected that the external power has been connected and the batteries are in backup mode.

Device Configuration alerts

A device configuration alert is sent when any of the conditions shown below are met.

• Device Configuration Installation

• Device Configuration Install Initiated

• Device Configuration Completed

• Device Configuration Completed with Errors

Firmware Update alerts

A firmware update alert is sent when any of the conditions shown below are met.

• Firmware Update Initiated

• Firmware Update Completed

• Firmware Update Completed with Errors

• Firmware Update Cancelled

GPS Location Update alerts

A GPS location update alert is sent when any of the conditions shown below are met.

• GPS Location Update

• GPS Location Update Requested

• GPS Location Update Success

• GPS Location Update Failed

• GPS Location Update Cancelled