Close the Connect Sensor XRT-M NEMA case
All Connect Sensor XRT-M NEMA products are shipped to you closed. You will need to open the device to wire third-party sensors to the Connect Sensor XRT-M NEMA I/O interface. After you have opened the enclosure, it may require some force to close. This is intended as part of the design to ensure a robust seal in damp or dusty environments.
Note Using gaskets, seals, glands or plugs other than those supplied by Digi may void certifications and regulatory approvals.
If you have problems closing the enclosure after either of these operations, please follow these instructions:
-
Ensure the gasket is fully seated in the groove on the enclosure.
-
Place the device on a flat, stable surface.
-
Apply pressure to the top of the Connect Sensor XRT-M NEMA until the top of the case snaps onto the body of the case.
Note The Connect Sensor XRT-M NEMA enclosure may require some force to close. This is intended as part of the design to ensure a robust seal in damp or dusty environments.