Disconnect the power supply from the RMS Z45

You can disconnect the RMS Z45 from the power supply, by disconnecting the power supply wires from the Pin 1 (negative) and Pin 2 (positive) terminals.

Tools needed

You will need a Phillips-head screwdriver to loosen and tighten the pins.

Follow the process below to disconnect the power supply from the RMS Z45.

1. Orient the RMS Z45 enclosure as shown.

   

2. Open the enclosure using the enclosure key. The accessory is attached to the DIN rail clip is on the right side of the device.

3. Unplug and remove the lower Phoenix connector from the RMS Z45.

4. Disconnect the wires.

   1. Use a Phillips-head screwdriver to loosen the screws for Pin 1 and Pin 2.

   2. Disconnect the black (negative) wire from Pin 1 (negative terminal).

   3. Disconnect the red (positive) wire from Pin 2 (positive terminal).

   4. Tighten the screws for Pin 1 and Pin 2.

      

5. Plug the lower Phoenix connector back into the RMS Z45.