Applicable hardware
This user guide contains information for these Connect EZ 8 models. Hardware features are shown in the table below.
| Feature |
Connect EZ 8 EZ08-A100
|
Connect EZ 8 Wi-Fi EZ08-B100
|
Connect EZ 8 MEI EZ08-C100
|
Connect EZ 8 I/O EZ08-D100
|
Connect EZ 8 I/O with ETH Switch EZ08-E100 |
|---|---|---|---|---|---|
|
Serial ports |
8 |
8 | 8 | 8 | 8 |
|
Cellular CORE Module |
X |
X |
X |
X |
X |
|
Wi-Fi |
X |
||||
|
MEI |
X |
||||
|
4-port Ethernet switch |
X |
||||
|
Micro SD |
X |
X |
X |
X |
X |
|
SFP+ ports |
2 |
2 |
2 |
2 |
|
|
AnywhereUSB USB ports |
2 |
2 |
2 |
2 |
2 |
|
Analog and digital I/O |
X |
X |
Warnings
-
This product is intended to be supplied by a UL listed (Certificate) power supply, output rated 12 VDC, 5 A minimum, TMA 55 degree C minimum, and altitude 5000 M. If you need further assistance, please contact Digi International Inc. support at +1 952.912.3444 or visit us at www.digi.com/support.
-
There is a danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type of battery as recommended by the manufacturer. Discard used batteries according to the manufacturer’s instructions.
-
The equipment power supply cord must be connected to a socket-outlet with earthing connection.
-
Never open the equipment. For safety reasons, the equipment should be opened only by a qualified, skilled person.
-
The equipment is not intended to be installed and used in a home, school, or public area accessible to the general population.
-
Thumbscrews should be tightened with a tool after both initial installation and subsequent access to the panel.
-
Laser Class 1 optical transceiver only should be used.
PDF
