Manually wake the Connect Sensor XRT-M NEMA

The Connect Sensor XRT-M NEMA is in sleep mode until it wakes to connect to Digi Axess at a scheduled time. You can wake the device manually, if needed, using the magnet supplied with the device. Waking the Connect Sensor XRT-M NEMA manually forces a connection to Digi Axess.

1. You must physically be near enough to the Connect Sensor XRT-M NEMA to touch it.

2. Locate the magnet sensor sticker on the side of the device.

   

3. Swipe a magnet across the magnet sensor sticker to wake the Connect Sensor XRT-M NEMA.

   

4. The LED on the edge of the SIM card slot shows the status of the device. Refer to the LED wake sequence in the table below.

5. The Connect Sensor XRT-M NEMA connects to Digi Axess when it successfully connects to the cellular network.

LED wake sequence

The LED on the edge of the SIM card slot shows the status of the device. When the device wakes, the device connects to Digi Axess and pushes any collected data, and collects any configuration changes that are pushed from Digi Axess. This process make take a few minutes.

Behavior	LED indication
Wake by user (as by magnet)	Red & Blue on together for 1 sec
While sensors are being sampled	Blue LED flashes (2Hz), generally on for a very short period
Cell initialized, trying to connect	Green LED flashes (2Hz)
Cell has connection	Green LED on solid
Cell completes with success	Blue LED on solid 3 sec
Cell completes with failure	Red LED on solid 3 sec
During firmware update	Toggle quickly between Red and Blue LED