Configure the WireGuard VPN

Your Connect EZ 2 device supports using WireGuard VPN. You can configure the device for either client or server mode. For client mode, your Connect EZ 2 is establishing an outbound WireGuard VPN connection to the WireGuard server. For server mode, your Connect EZ 2 is acting as a WireGuard server and accepts incoming WireGuard VPN connections from one or more client devices. Regardless of how you configure the device, you will need to create a Wireguard tunnel and corresponding interface.

To configure the WireGuard VPN:

  1. Decide the WireGuard mode for your Connect EZ 2: Client or Server.

    • Client mode - The device establishes an outbound WireGuard VPN connection.

    • Server mode - The device acts as a WireGuard server.

  2. Gather the required information for the mode you chose.

    Required information for Client mode

    • Private key

    • Remote endpoint address or hostname

    • Remote endpoint port

    • Remote endpoint public key

    • Preshared key (optional)

    • Local and remote IP addresses

    Required information for Server mode

    • Client public key

      This key can come from the client device or you can generate it from the Digi device’s Admin CLI console using the wireguard generate [tunnel_name] [client_name] command after configuring the Wireguard server settings on the Digi device.

    • Pre-shared key (optional)

    • Local and remote IP addresses

  3. Choose the management interface you want to use to access your device. Click a dropdown for instructions.

  4. Create a WireGuard tunnel.
  5. Create the WireGuard interface.

þ You have finished configuring the WireGuard VPN by creating a new tunnel and interface.