Locate the device by using the Find Me feature

Use the Find Me feature to cause LEDs on the device to blink, which can help you to identify the specific device. For the Connect EZ, the Power LED blinks when the Find Me feature is in use.

To use this feature:

 Web

Log into the Connect EZ WebUI as a user with full Admin access rights.

On the menu, click System. Under Administration, click Find Me.
A notification message appears, noting that the LED is flashing on the device. Click the x in the message to close it.

On the menu, click System again. Ablue circle next to Find Me is blinking, indicating that the Find Me feature is active.
To deactivate the Find Me feature, click System and click Find Me again.
A notification message appears, noting that the LED is no longer flashing on the device. Click the x in the message to close it.

 Command line

Select the device in Remote Manager and click Actions > Open Console, or log into the Connect EZ local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection menu. Type admin to access the Admin CLI.
To activate the Find Me feature, at the prompt, type the following at the command prompt:
```
> system find-me on
> 
```
To deactivate the Find Me feature, type the following at the command prompt:
```
> system find-me off
> 
```
To determine the status of the Find Me feature, type the following at the command prompt:
```
> system find-me status
off
> 
```