Attach a DIN rail clip (AnywhereUSB Plus 2-port ONLY)

Note You can attach a DIN rail clip only to a AnywhereUSB Plus 2-port device.

You must purchase a DIN rail mounting kit: Digi PN 7000682.
You will need an appropriate Phillips-head screwdriver.
Set of two screws from the DIN rail mouning kit. The kit contains two sets of screws. Only the black set can be used with the AnywhereUSB Plus 2-port device.
- Black screws: Set of two: 4 x 40 x 0.250, Phillips-head, zinc-plated screws. These screws are required for use with the AnywhereUSB Plus 2-port device.
- Silver screws: This set cannot be used with AnywhereUSB Plus 2-port device and can be disregarded.
  
  Note Some kits may not have the required screws included. If this occurs, you will need to separately purchase two screws of the following type: 4 x 40 x .250 Flat or Phillips-head, zinc-plated screws.

Remove required items from DIN rail mounting kit:
- DIN rail clip
- Two black 4 x 40 x 0.250 screws
Place the DIN rail clip on the rear panel of the device. Make sure the screw holes are aligned.
In each hole, use a Phillips-head screw driver to screw in a 4 x 40 x 0.250 screw.
Tighten the screws as needed to securely fasten the DIN rail clip to the device.
Use the DIN rail clip to mount the device to a rail.