Use policy routes with hotspot

When creating policy routes for hotspots, the source address should be set to use the hotspot zone:


  Web

  1. Create a new routing policy. See Configure a routing policy for instructions.
  2. During configuration, for Source address:
    1. For Type, select Zone.
    2. For Zone, select hotspot.
  3. Click Apply to save the configuration and apply the change.
  1. Create a new routing policy. See Configure a routing policy for instructions.
  2. During configuration, set the source address type to zone:
    (config network route policy 0)> src type zone
(config network route policy 0)>
  3. Set the zone to hotspot:
    (config network route policy 0)> src zone hotspot
(config network route policy 0)>
  4. Save the configuration and apply the change.
    (config)> save
Configuration saved.
>
  5. Type exit to exit the Admin CLI.

    Depending on your device configuration, you may be presented with an Access selection menu. Type quit to disconnect from the device.