Log in to the command line interface


  Command line

  1. Connect to the EX15 device by using a serial connection, SSH or telnet, or the Terminal in the WebUI or the Console in the Digi Remote Manager. See Access the command line interface for more information.

    Note Telnet is not available when Primary Responder mode has been enabled for the device. For information about Primary Responder mode, see Differences between standard firmware operation and Primary Responder mode.

    • For serial connections, the default configuration is:
      • 9600 baud rate
      • 8 data bits
      • no parity
      • 1 stop bit
      • no flow control
    • For SSH and telnet connections, the Setup IP address of the device is on the .
  2. At the login prompt, enter the username and password of a user with Admin access:
    login: admin
Password: **********

    The default username is admin. The default unique password for your device is printed on the device label.

  3. Depending on the device configuration, you may be presented with another menu, for example:
    Access selection menu:

	a: Admin CLI
	s: Shell
	q: Quit

Select access or quit [admin] :

    Type a or admin to access the EX15 command line.

You will now be connected to the Admin CLI:

Connecting now...
 Press Tab to autocomplete commands
 Press '?' for a list of commands and details
 Type 'help' for details on navigating the CLI
 Type 'exit' to disconnect from the Admin CLI

>

See Command line interface for detailed instructions on using the command line interface.