Enable BLE and configure the BLE password using XCTU

Some of the latest XBee 3 modules support Bluetooth Low Energy (BLE) as an extra interface for configuration. If you want to use this feature, you have to enable BLE. You must also enable security by setting a BLE password on the XBee device in order to connect, configure, or send data over BLE.

The BLE password is configured using XCTU. Make sure you have installed or updated XCTU to version 6.4.2. or later. Earlier versions of XCTU do not include the BLE configuration features. See Download and install XCTU for installation instructions.

Before you begin, you should determine the password you want to use for BLE on the XBee device and store it in a secure place. Digi recommends a secure password of at least 8 characters and a random combination of letters, numbers, and special characters. Digi also recommends using a security management tool such as LastPass or Keepass for generating and storing passwords for many devices.

Note When you enter the BLE password in XCTU, the salt and verifier values are calculated as you set your password. For more information on how these values are used in the authentication process, see BLE Unlock API - 0x2C.

  1. Launch XCTU .
  2. Switch to Configuration working mode .
  3. Select a BLE compatible radio module from the device list.
  4. In the Bluetooth Options section, select Enabled[1] from the BT Bluetooth Enable command drop-down.

  1. Click the Write setting button . The Bluetooth authentication not set dialog appears.

    Note If BLE has been previously configured, the Bluetooth authentication not set dialog does not appear. If this happens, click Configure in the Bluetooth Options section to display the Configure Bluetooth Authentication dialog.

  2. Click Configure in the dialog. The Configure Bluetooth Authentication dialog appears.

  1. In the Password field, type the password for the device. As you type, the Salt and Verifier fields are automatically calculated and populated in the dialog as shown above. Make a note of the password, as this password is used when you connect to this XBee device via BLE using the Digi XBee Mobile app.
  1. Click OK to save the configuration.