IB (Cellular Component Baud Rate)
This command applies to the XBee Smart Modem.
Note Digi does not recommend using bypass mode. You should use USB Direct mode instead.
Sets the serial interface baud rate for communication between the XBee CPU and the cellular component when in bypass mode. You can set bypass mode by setting the AP command to 5. You must configure the cellular modem to use the same baud rate (AT+IPR) prior to changing this setting.
Parameter range
| Parameter | Description |
|---|---|
| 0x0 | 1200 b/s |
| 0x1 |
2400 b/s |
| 0x2 | 4800 b/s |
| 0x3 | 9600 b/s |
| 0x4 | 19200 b/s |
| 0x5 | 38400 b/s |
| 0x6 | 57600 b/s |
| 0x7 | 115200 b/s |
| 0x8 | 230400 b/s |
| 0x9 | 460800 b/s |
| 0xA | 921600 b/s |
Default
Telit based modules: 0x7 (115200 baud)
PDF
