Configure the device

  1. Ensure that the device is set up correctly with the SIM card installed and the antennas connected as described in Connect the hardware.
  2. Open XBee Studio and Add a device to XCTU (this should happen automatically).

  3. Navigate to the device settings page by one of the following methods:

    • Hover over your device and then click Open Settings.
    • Click on your device and then click Settings in the left menu.
    • Click Configuration in the sidebar, then click Settings, then finally click on your device.

  4. To switch to UDP communication, in the IP field, select 0 and click the Write button .

  5. To set the target IP address that the XBee Cellular Modem will talk to, in the DL field type 52.43.121.77and click the Write button . A CoAP server is publicly available at address 52.43.121.77.

  6. To set the XBee Cellular Modem to send data to port 5683 in decimal, in the DE field, type 1633 and click the Write button.

  7. To move into Transparent mode, in the AP field, select 0 and click the Write button.
  8. Wait for the AI (Association Indication) value to change to 0 (Connected to the Internet). You can click Read to get an update on the AI value.