IC (Digital Change Detection)

This command applies to the XBee 3 Zigbee RF Module.

The bit field that configures which digital I/O pins should be monitored for digital change detection. If the device detects a change on an enabled digital I/O pin, it immediately transmits a digital I/O sample to the address specified by DH +DL.

Change Detect is edge-triggered and must occur while the device is awake. If the level transition occurs during a sleep period, the device will not see a change.

Bit field

Bit	I/O line	Micro pin	Surface-mount pin	Through-hole pin
0	DIO0	31	33	20
1	DIO1	30	32	19
2	DIO2	29	31	18
3	DIO3	28	30	17
4	DIO4	23	24	11
5	DIO5	26	28	15
6	DIO6	27	29	16
7	DIO7	24	25	12
8	DIO8	9	10	9
9	DIO9	25	26	13
10	DIO10	7	7	6
11	DIO11	8	8	7
12	DIO12	5	5	4
13	DIO13	3	3	2
14	DIO14	4	4	3

Parameter range

0 - 0x7FFF

Default

0