Show Contents

AG (Aggregator Support)

This command applies to the XBee/XBee-PRO S2C DigiMesh 2.4.

The AG command sends a broadcast through the network that has the following effects on nodes that receive the broadcast:

• The receiving node establishes a DigiMesh route back to the originating node, if there is space in the routing table.
• The DH and DL of the receiving node update to the address of the originating node if the AG parameter matches the current DH/DL of the receiving node.
• API-enabled devices with updated DH and DL send an Aggregate Addressing Update frame (0x8E) out the serial port.

Parameter range

Any 64-bit address

Default

N/A