MD (RF Mode)
This command applies to the XTC RF Module.
Sets or displays the settings that enable the Polling and Repeater modes on the device.
Polling Mode: a Polling Base is responsible for polling remotes. A Polling Remote requires a poll from a Polling Base in order to transmit.
Repeater Mode: a Repeater re-sends RF data unless the transmission is addressed to it or if it has already detected the transmission. A Repeater End Node handles repeated messages, but will not repeat the message over-the-air.
For more information, see Basic communications.
Binary command
0x31 (49 decimal)
Parameter range
0 - 6
| Parameter | Configuration |
|---|---|
| 0 |
Transparent Operation (Repeater Base) |
| 1 | Reserved - not used |
| 2 | Reserved - not used |
| 3 | Polling Base |
| 4 | Polling Remote |
| 5 | Repeater |
| 6 | Repeater End Node |
Default
0
Bytes returned
1
PDF
