Default behavior with the cellular network

For cellular networks, the default behavior for XBee Gateway is as follows:

• The default behavior regarding NTP time server access, Configure Remote Manager connectivity settings, and DNS server all proceed as described.
• You must connect XBee Gateway to the cellular network. How you connect XBee Gateway to the cellular network depends on the type of cellular modem in the device.
• First-time activation of an XBee Gateway in a cellular network could take up to five minutes or longer.
• For Verizon service, generally, if a mobile connection bring-up fails within 30 seconds, the device will wait before trying again.
• If only a 3G signal is available, but no 1xRTT signal, the device will not provision. If only an 1xRTT signal is available but no 3G signal, the device will provision, but it will operate at a slower speed.
• Signal strength, account registration, and other issues can impact activation. For common issues and resolutions, see Cellular connection issues.
• The XBee Gateway cellular module sends a single SMS message, containing the device's phone number, to register the device with Remote Manager Technical Support, as described in Remote Manager SMS opt-in. Your cellular account must be set up to send and receive SMS messages.