Attach the Ethernet cable

You can attach an Ethernet cable to the device so that you configure your device using the local web user interface. The Ethernet cable is attached inside the device.

Note You can also route an Ethernet cable outside the device enclosure. See Cable fittings.

  1. Open the device if it is not already open.
  2. Connect one end of the Ethernet cable to the ConnectPort X4 H.
  3. Connect the other end of the Ethernet cable to your PC.
  4. Close the device.

    Note Digi recommends that you use 2.5 inches per pound of torque when tightening the screws. You should tighten the screws in a criss-cross pattern to ensure that the cover is not bent or skewed during this process.