display passthrough

Purpose

Displays status of the IP pass-through mode, which is enabled by the set passthrough command.

Required permissions

For Digi products with two or more users, permissions must be set to set permissions display=execute to use this command. See set permissions for details on setting user permissions for commands.

Syntax

display passthrough

Examples

The following is an example command when IP pass-through is not enabled (that is, the Digi device is operating in its normal mode):

#> display passthrough

IP Pass-through Mode Status:

    boot state                 : off
    current status             : inactive
    current ip address         : 0.0.0.0
    current gateway            : 0.0.0.0
    current subnet mask        : 0.0.0.0
    current proxy arp          : inactive
Add an example w/ IP passthrough mode already set up.

See also

set passthrough