Serial settings

• Enable Port Logging: Port logging allows you to save serial data to the memory of the Digi device server. Once enabled, the port log can be viewed by selecting Port Logs on the Serial Port Management page (Management > Serial Ports). Port Logging is enabled in the CLI via the set buffer command.
• Log Size: The size in kilobytes of the memory buffer used to save serial data when port logging is enabled.
• Automatic backup: The port data is stored to specified location automatically.
• Unlimited automatic backup size: When enabled, the automatic backup size is not limited.
• Automatic backup size: This option defines the amount of the log to backup at a time.
• Enable SYSLOG service: The port data can be stored to the SYSLOG server in addition to the port log storage location at the same time.

• Enable RTS Toggle: When enabled, the Digi device asserts RTS (Request To Send) when sending data on the serial port.

• Enable RCI over Serial (DSR): This choice allows configure the Digi Connect device through the serial port using the RCI protocol. See the RCI specification in the Digi Connect Integration Kit for further details.

  RCI over Serial uses the DSR (Data Set Ready) serial signal. Verify that the serial port is not configured for autoconnect, modem emulation, or any other application which is dependent on DSR state changes.

• Enable alternate pinout (altpin): Enables or disables the altpin option, which swaps DCD with DSR so that you can use eight-wire RJ-45 cables with modems. By default, the altpin is disabled.