Use the RESET button to reset your device to the factory defaults

You can reset the Connect EZ to the factory default settings. Resetting the device to factory defaults performs the following actions:

• Clears all configuration settings.
• Deletes all user files.
• Regenerates SSH keys.
• Clears event and system log files.
• Creates a new event in the event log, indicating a factory reset.

Note While the settings are reset, the device's firmware version remains the same.

1. Make sure that the Connect EZ has been powered on for at least 30 seconds.
2. Locate the RESET button on the back of the device.

   

3. Using a pinhole tool, press and hold the RESET button. The RESET button has the following modes:
   • Configuration reset:
     • Press and release the RESET button for 10 seconds.
     • The device reboots automatically and resets to factory defaults. This does not remove any automatically generated certificates and keys.
   • Full device reset:
     • After the device reboots from the first button press, immediately press and release the RESET button for 10 seconds again.
     • The device reboots again and resets to factory defaults, as well as also removing generated certificates and keys.