Special conditions for safe use (ATEX)

Digi complies with the ATEX Directive to ensure a safe working environment when working with equipment in potentially explosive atmospheres. The Connect Tank device is compliant to the ATEX Directive under Certification DEMKO 14 ATEX 1416X.

Applicability

Connect Tank has been evaluated according to the following conditions. The ATEX evaluation and the special conditions in this section apply to part numbers 50001884-xx.

WARNING! Connect Tank is suitable for use in ATEX Zone 2, Group IIC hazardous locations or non-hazardous locations only.

WARNING! The Connect Tank unit should not be installed in process tanks containing either pressurized or flammable materials. The battery should be replaced in unclassified areas only.

WARNING! Connect Tank is intended for fixed installation, where the installation is intended to minimize the risk from electrostatic discharge. Follow all installation safety guidelines in this section to minimize the risk from electrostatic discharge.

WARNING! Install Connect Tank in an area that does not have more than pollution degree 2 as defined in EN/ IEC 60664-1.

WARNING! To avoid potentially dangerous electrostatic discharges, control all likely ignition sources, minimize the harmful effects of any accidental fire or explosion by using explosion relief and suppression systems. All zoned areas containing potentially explosive atmospheres should be clearly marked using ATEX Ex hazardous area warning signs.

WARNING! Potential electrostatic charging hazard. To avoid building up an electrostatic charge when cleaning the enclosure of this device, you must use a damp cloth moistened only with water. Do not use flammable cleaning agents.