Reboot the AnywhereUSB

Changes to some device settings require saving the changes and rebooting the AnywhereUSB.

To reboot the device from the web UI:

1. Access and log in to the web user interface.
2. Select Administration > Reboot.
3. Click Reboot. Wait approximately 1 minute for the reboot to complete.

To reboot the device using the front panel Reset button:

1. Hold down the front panel Reset button for about 2 seconds, until the front panel LEDs start blinking an amber color.
2. Quickly release the Reset button then hold it down again.
3. Wait about 4 seconds, until the front panel LEDs flicker then turn off.
4. Release the Reset button.

Note This reboot procedure is only applicable when the AnywhereUSB is in a normal operational state, such as when the System Status LED is blinking green. If the System Status LED is repeatedly blinking red (instead of slow green), please contact Digi Technical Support at www.digi.com/support.