Configure the IP address with Digi Device Discovery Utility

Use the Digi Device Discovery Utility to:

• View the IP address of an AnywhereUSB device.
• Configure a static IP address when the AnywhereUSB does not obtain an IP address from a DHCP server (such as when there is no available DHCP server).

Note You must run the Digi Device Discovery Utility from a computer on the same subnet as the AnywhereUSB. If discovery fails, make sure that the Microsoft Windows Firewall is off. For additional troubleshooting help, visit the Digi Knowledge Base at knowledge.digi.com.

To configure a static IP address using the Digi Device Discovery Utility:

1. Download and install the Digi Device Discovery Utility:

1. Go to www.digi.com/support#support-tools.
2. From the Support Downloads section, click Drivers.
3. Find and select Device Discovery from the product list.
4. From the Diagnostics, Utilities and MIBs drop-down list, select your operating system.
5. Download the utility for your operating system and install it.

6. Open the Digi Device Discovery Utility.
7. Right-click your AnywhereUSB device and select Configure network settings.
8. Type the IP address, subnet mask, and default gateway.
9. Click Save.