Cable fittings

To route serial, Ethernet or sensor cables outside the enclosure, and maintain IP66 rating, you can replace the three hole plugs with cable fittings, available in different diameters. You can purchase these cable fittings separately from Digi.

To wire sensors through cable fittings:

1. If you are routing an Ethernet cable, connect one end of the Ethernet cable to the Ethernet port on the device.
2. Locate cord grip to attach sensor. Different diameter cord grips are available for different sensors, please contact Digi for purchase.
3. Wire sensor to the 14-pin connector plug using the pinout guide provided in the enclosure or in Connector pinouts. You can wire up to 4 sensors into the 14-pin connector.

Note Ensure that all cable fittings are tightened and all empty holes are plugged before use to maintain environmental rating.