display netdevice

Purpose

Displays the active network device interfaces on the system, for example, PPP and Ethernet interfaces, and their status, such as Closed or Connected.

Required permissions

For Digi products with two or more users, permissions must be set to set permissions display=execute to use this command. See set permissions for details on setting user permissions for commands.

Syntax

display netdevice

Examples

#> display netdevice
 Device Table:

 Name     PhysAddr          Status
 vpn4     NA                closed
 vpn3     NA                closed
 vpn2     NA                closed
 vpn1     NA                closed
 vpn0     NA                closed
 eth0     00:40:9D:29:8D:07 connected
 vrrp7    NA                closed
 vrrp6    NA                closed
 vrrp5    NA                closed
 vrrp4    NA                closed
 vrrp3    NA                closed
 vrrp2    NA                closed
 vrrp1    NA                closed
 vrrp0    NA                closed
 LOOPBACK NA                connected


 Device Entry IP Configuration:
 Name     Family mHome Type   Status      IPAddress
 eth0     IPv4   0     manual configured  10.8.115.10/16
 LOOPBACK IPv4   0     manual configured  127.0.0.1/32

See also

• The set commands for configuring network device interfaces.
• The display commands for displaying current network device interface states.
• The Network Port Scan Cloaking feature allows you to configure a Digi device to ignore (discard) received packets for services that are hidden or not enabled and network ports that are not open. Scan cloaking can be performed on all connection requests, or for certain types of requests for particular network interfaces. See set scancloak.